ZHANG Jinhong, SHI Wenbing, LIU Yongzhi, ZHU Yongdong, WANG Xiaoming. 2026: Deformation and failure characteristics of layered mining slopes with different bedding spacings. Journal of Mountain Science, 23(10): 5089-5108. DOI: 10.1007/s11629-026-0670-0
Citation: ZHANG Jinhong, SHI Wenbing, LIU Yongzhi, ZHU Yongdong, WANG Xiaoming. 2026: Deformation and failure characteristics of layered mining slopes with different bedding spacings. Journal of Mountain Science, 23(10): 5089-5108. DOI: 10.1007/s11629-026-0670-0

Deformation and failure characteristics of layered mining slopes with different bedding spacings

  • Layered mining slopes with hard-over-soft lithological structures and steep-over-gentle slope morphologies are widely developed in the karst mountainous areas of Southwest China, where underground coal mining can easily induce collapse and landslide hazards. Existing studies have focused mainly on individual engineering cases and the deformation and failure process of mining-induced overburden strata, while the influence of bedding spacing, a key structural parameter, on slope deformation response, fracture propagation, and failure mode remains insufficiently understood. Taking the Wanzitou collapse in Zhijin, Guizhou, China, as the geological prototype, this study used the PFC2D discrete element method to establish a generalized model of a layered mining slope with a random joint network. Four bedding spacing conditions of 10 m, 30 m, 50 m, and 100 m were established to analyze the displacement, stress, fracture evolution, and failure modes of the slope under mining disturbance. The main findings are as follows: (1) after excavation of the first coal seam, with increasing bedding spacing, the maximum horizontal displacement of the slope decreased from 0.87 m to 0.29 m, and the peak YY-direction stress decreased from 5.3 MPa to 3.1 MPa, indicating that greater bedding spacing can increase the overall stiffness of the rock mass and reduce early deformation and local stress concentration; (2) in the later mining stage, slope deformation is jointly controlled by fracture coalescence, block toppling, toe bulging, and shear displacement along structural planes, and the displacement response shows stage-dependent and nonmonotonic characteristics. After mining equilibrium was reached, the slope under the 10 m condition experienced the most severe deformation, with maximum vertical and horizontal displacements of 277.3 m and 106.3 m, respectively. The slope under the 30 m condition had the smallest displacement response, with a maximum surface settlement of approximately 8.5 m. Under the 50 m and 100 m conditions, differential deformation near structural planes was obvious, with a maximum differential displacement of 8.7 m; (3) fracture evolution can be divided into three stages: initial cracking, stable propagation, and accelerated propagation. A smaller bedding spacing results in more fractures and stronger fracture connectivity, making it easier to form a throughgoing rupture zone; and (4) the failure modes differ significantly under different bedding spacing conditions. The 10 m condition shows a collapse–sliding failure mode, the 30 m condition shows a toppling failure mode, and the 50 m and 100 m conditions show a coupled toppling–sliding failure mode. The results indicate that bedding spacing is an important structural factor controlling the progressive failure and failure mode transition of layered mining slopes and can provide a reference for failure mode identification and disaster prevention of similar mining slopes.
  • loading

Catalog

    Turn off MathJax
    Article Contents

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return